How do I setup a router for NanoStation?

How do I setup a router for NanoStation?

How do I setup a router for NanoStation?

Using Ethernet cables, connect the following:

  1. Connect the LRS gateway to the “Secondary” port on the router.
  2. Connect the “Main” port on the router to the “POE” port on the power adapter.
  3. Connect the “LAN” port on the power adapter to your internet source (optional)

How do I reset my NanoStation M5 to factory settings?

Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the NanoStation is powered on. Alternatively, a remote reset button is located on the bottom of the PoE Adapter. * Main is labeled LAN on the NanoStationlocoM2/M5.

How does NanoStation M5 work?

We install a wireless device (either a Ubiquiti Nanostation M5 or Ubiquiti Nanostation Loco M5 depending on location) on the outside of your premises which then points to our network of repeater stations. This then passes the signal back to our core router, which then passes it to the internet.

What is the use of NanoStation M5?

The NanoStation M5 can be used as an access point, connecting to hundreds of devices all at the same time, or as a client, which can be connected to other networks through a bridge. The level of flexibility makes this a fantastic and convenient addition to your networking system.

How do I connect my NanoStation to WIFI?

Connection

  1. Turn on Sphere PoE.
  2. Connect Sphere PoE jack to either NanoStation M5 Ethernet port (Primary or Secondary)
  3. Connect one of the remaining available Ethernet ports on the Sphere or the NanoStation to a local router / Internet-connected network.

How do I set Ubiquiti device to point-to-point?

User Tips

  1. Select the correct cable. Use Ubiquiti ToughCable Pro shielded twisted pair data cable between your Power over Ethernet adapter and your radio.
  2. Secure the radios. Modify the default administration account name and password now.
  3. Secure the wireless signal. Encrypt the wireless connection.

How do I setup a wireless point-to-point?

  1. Step 1: Determine your computer IP address.
  2. Step 2: Connect the AP to your network.
  3. Step 3: Login to the AP.
  4. Step 4: Change default password.
  5. Step 5: Configure the AP to Access Point Mode.
  6. Step 6: Turn on MIMO Signal Transmission on Ubiquiti Radios.
  7. Step 7: Configure the Radio’s IP Address to Avoid IP Conflicts.

How do I reset my Ubiquiti Airmax?

Press the reset button on the device. While holding the reset button down, power the unit on. Wait 8 seconds then release the button (if you want to reset the unit to factory defaults, wait about 15 seconds or until the signal LEDs light up to indicate that the device is ready for recovery).